Our Partial Discharge Masterclasses are Now Open!
Don't miss your opportunity to learn, understand and gain knowledge in all aspects of PD Measurement and Monitoring from basic principles to advanced - provided by super in house regional specialist Florian Predl.

INTRODUCTION TO PD MEASUREMENT AND MONITORING
Masterclass 1

October 7, 2021 | Australia | 2 hours | Virtual
12pm AEDT
 

Become familiar with the basic principles of partial discharge measurements. Ge to know how to set-up and measure according to IEC 60270. Benefit from an introduction to basic principles of interpreting test results.

Objectives

Understand what partial discharge (PD) is
Get to know the measurement methods for partial discharge
PD Monitoring on power assets

Topics

What is partial discharge
Understanding how partial discharges are measured
Getting an overview of components and connection options of the MPD 800 and the permanent monitoring solutions
Noise suppression techniques
Getting an insight on PD test results using recorded streams of actual measurements
Basic principles of interpreting partial discharge test results
Case studies

Don't miss out with limited spaces available, register below to secure your place!
 

PD MEASUREMENT AND LOCALIZATION OF POWER TRANSFORMERS
Masterclass 2

October 21, 2021 | Australia | 2 Hours | Virtual
12pm AEDT

Do you measure partial discharges (PD) on power transformers?
Get to know the coupling methods and new features of the MPD 800 technology. The MPD 800 allows to set for standard complaint PD measurements. PD measurement and localization will be demonstrated on a mobile power transformer.

Objectives

Overview of PD measurements on power transformers
Dangerous partial discharges on power transformers - Introduction
Get to know the MPD 800 acquisition unit and the requirements in terms of measurement setup and MPD Suite software settings
Get to know PD fault localization possibilities based on acoustic measurement sensors

Topics

PD measurements on power transformers
PD coupling methods on power transformers
Advantages of the new MPD 800 technology in terms of power transformer PD measurements
Practical example – PD measurement and localization on a 220kV power transformer
Case study

Join us below to fine tune your skillset and overcome any challenges faced on site!
 

PD MEASUREMENT AND LOCALIZATION OF POWER CABLES
Masterclass 3

November 4, 2021 | Australia | 2 Hours | Virtual
12pm AEDT

Do you measure partial discharges (PD) on power cables?
Get to know possible coupling methods for PD detection and learn about the new features of the MPD 800 supporting you in PD measurement and localization on power cables. Based on an example of a MV power cable available coupling methods and possibilities for fault localization are explained.

Objectives

Overview of PD measurement on power cables
Get some basic understanding about PD monitoring
Get to know the MPD 800 acquisition unit and the requirements in terms of measurement setup and MPD Suite software settings
Possibilities to localize defects emitting PD activity on power cables
Understand methods to separate and interpret different PD defects

Topics

PD measurement and analyze PD pattern on power cables
PD coupling methods on power cables
Introduction to noise suppression techniques
Possibilities to localize PD activity on power cables using MPD 800
Practical example on PD detection and localization on a MV VPE cable
Case studies

Don't miss your out! Join us below